MIC 10 DL

Hardness tests are always an issue and here we can fall back on the MIC 10.

We are using an UCI (Ultrasonic Contact Impedance)

  • Hardness testing on site according to the UCI method (Ultrasonic Contact Impedance)
  • Standardized according to ASTM A 1038
  • Probes with test loads from 1 N (HV 0.1) and 98 N (HV 10)
  • Automatic conversion into different hardness scales and tensile strength (only 98 N-probe)
  • Display of individual values or averages of a series of tests
  • Data logger versions with internal data storage for data and device settings

Test Methods:

Hardness testing with Vickers indenter (126° diamond pyramid), evaluation of the test indentation under load.

PCE-HT200

With this tester, the hardness of rubber can be determined. The accuracy is 0.1 hardness units.

  • Can be used both mobile and stationary
  • Compliance with all current standards of hardness tests
  • Holds the maximum value (peak hold)
  • Suitable for single and series measurements
  • Data transfer to PC or laptop possible

Technical Data

  • Measuring Range: 0 … 100
  • Resolution: 0,1 Hardness – Grade
  • Accuracy: ±1 Hardness – Grade
  • Displayable values: Current hardness, maximum value, average value (maximum value is kept)
  • PC-Interface: RS-232
  • Data cable: Optional assembly
  • Further functions: Auto shut-off, low battery display
  • Power supply: 3 x Batterie 1,25 V (V357)
  • Battery life span: ca. 300 h
  • Operating temperature: 0 … +40 °C
  • Dimensions: 168 x 31 x 30 mm
  • Weight: 145 g

Krautkramer TIV Hardness Tester

Using a special lens, the innovative TIV method (Through Indenter Viewing) uses a direct optical evaluation of the diamond according to Vickers indentation under load. The image of the impression is transmitted to the display device and is evaluated automatically.

  • Hardness testing according to Vickers under test load
  • Look through the Vickers diamond using a special optical system and a CCD camera
  • Direct control and evaluation of the quality of the measured value by checking the impression on the color screen
  • Fully automatic evaluation of the diamond indentation and immediate determination of the diagonal lengths
  • Independent of the test direction and the material of the specimen
  • Measuring range is from 30 HV up to over 1000 HV (depending on probe)

Technical Data:

Base Instrument

  • Weight: ca. 1400g (incl. battery pack)
  • Display: 14,5cm TFT, 240×320 Pixel

Probe

  • Housing: VA, Aluminium
  • Weight: ca. 630g
  • Protection: IP 42

Interface

  • RS-232: bidirectional, 9-pol. Sub-D
  • Ethernet: 10MBit/s
  • Special Cable Connector: 20-pol. AMP 050
  • Power Supply: Low voltage socket 12V 2A

Evaluation

  • Measuring Methods: TIV (Through-Indenter-Viewing) with Vickers Diamond
  • Penetration Method: Diamond Pyramid according to Vickers, Roof Angel 136°
  • Measuring Tolerance: ±3,6% maximum deviation of the average from 5 measurements from nominal value of the best block. (for measurements at room temperature)
  • Span: 5% maximal (200 … 900 HV), depending on the material, surface and temperature
  • Statistic: Average, Span, Standard deviation, Min., Max., Process Capacity Index
  • Conversion: According to DIN 50150, ASTM E140
  • Conversion Scales: HV, HB, HRB, HRC, HS, N/mm2


DE EN